DMSO, Turpentine, and Colloidal Silver for Cysts

The comments below reflect the personal experiences and opinions of readers and do not represent medical advice or the views of this website. The information shared has not been evaluated by the FDA and is not intended to diagnose, treat, or prevent any disease or health condition. Always consult a qualified healthcare professional for medical concerns.
DMSO, Colloidal Silver, Turpentine
Posted by Dave (Fountain Inn, Sc ) on 05/05/2015
★★★★★

I have used a few methods of dealing with surface cysts and below skin cysts. I say cysts; but I "lump" fatty tumors; cysts of mass as well as fluid in a single group.

I first want to make sure the cyst is not caused by infection or accompanied by infection. So I place on the site a poultice of colloidal silver mixed with DMSO. I let that sit for fifteen minutes on the surface.

I have also used a charcoal poultice and a turpentine poultice. I mix the turpentine with DMSO and colloidal silver. The turpentine is caustic so I don't put too much on skin for too long.

I've used Healing Clay. Not as a poultice. I just put a half spoonful of the clay with colloidal silver and then place the "goo" onto the site. I let dry.

All the above I repeat many times.

JUST in the past three days I found a number of "nodules" on my chest wall. They were sore and the size of a pencil eraser. I used the colloidal silver and turpentine plus DMSO on day one. Day two I used colloidal silver with tea tree oil and DMSO as a poultice and then did a colloidal silver with turpentine and DMSO poultice. The nodules covered an area about the size of three by four inches.

In only two days the sensitivity is down by 80 percent and the size of the five or six nodules is reduced by over half. I theorize I had an infection perhaps in my lymph glands. I will continue this poultice application for a month.